Lectrosonics VS1 Manuale Utente

VS1 VIDEO SWITCHER INTERFACE OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE 1) Video image "rolls" when cameras are switched. 1) Auto Sync set to "Off" 2) No sync si

SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was p

INTRODUCTION The VS1 Video Switcher Interface is a microprocessor-based controller used between an automatic microphone mixer and a video switcher.

THEORY OF OPERATION The general operation of the VS1 will be described in this section, while the specifics of each programmable option will be outli

VS1 FUNCTIONS Input Time Delay - Input Time Delay may be adjusted between 0.1 and 10 seconds. This parameter represents the delay between activity o

VS1 Function Summary and Default Settings (Version 1.2 firmware) Feature / Function Range Factory Default Input Time Delay Outputs 1 thru 8: 0.1 to

FRONT PANEL DESCRIPTION SELECT PUSHBUTTON - Selects the area on the LCD display for which the Up and Down pushbuttons are active. The blinking cursor

INSTALLATION The VS1 has eight logic inputs, eight logic outputs, and a video synchronization input. The logic inputs provide the interface to an au

SETUP PROCEDURE After the VS1 is installed as outlined in the Installation section (page 6) adjustments may be made to optimize the performance. The

5. Set the IDLE option to either HOLD or OVERVIEW. The Hold setting will keep the last active output on, while the Overview setting will switch to th